Removing and installing luggage compartment side trim, Multivan, rear, side of vehicle with sliding door — AUDI

🧭 Before you start

Fits: platform codes SF, SG

• Renewed: if necessary

Don't miss

• Before installing, check all fasteners for damage and renew if necessary.Following installation, ensure that trim is positioned in door seal beading.

📋 Procedure

1. Switch off ignition.
2. Remove upper C-pillar trim .
3. Remove D-pillar trim .
4. Remove lock carrier trim .
5. Remove bolts (3).

6. Remove fastening ring (4).
7. Pull out clamping pins (2).
8. Release side trim (1) from mountings.
9. Detach wiring harnesses from side trim.
10. Remove side trim (1) from vehicle. [Note: Before installing, check all fasteners for damage and renew if necessary.Following installation, ensure that trim is positioned in door seal beading.]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing torque reaction support and cross member
• Removing and installing camshaft oil seal – Audi TT Mk2
• Removing and installing trailing arm with mounting bracket, front-wheel drive vehicles
• Adjusting toe setting at front wheels – Audi R8 · 2 torque figures
• Removing front seat with electric adjustment if seat longitudinal adjustment motor is defective