Removing and installing left luggage compartment trim (Estate) — VW

🧭 Before you start

Fits: platform code 1H1

Don't miss

• Make sure the sealing on the rear lid is seated correctly.

📋 Procedure

1. Remove rear bench seat and backrest .
2. Remove luggage compartment cover .
3. Remove upper B-pillar trim .
4. Remove upper C-pillar trim .
5. Remove lower C-pillar trim .

6. Remove D pillar trim panel .
7. Removing load sill cover .
8. Remove cross-head screw .
9. Remove lid and clips .
10. Unscrew hexagon nuts .
11. Pull trim with securing peg at right angles out of clip and pull upwards out of clips .
12. Check the seating of the clips and and correct if necessary.
13. Make sure the sealing on the rear lid is seated correctly.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing wheel bearing unit, disc brakes, torsion beam axle
• Removing and installing inner door seal, Cabriolet
• Removing and installing dash panel cover on front passenger side, cover with reinforcement
• Removing and installing rear seat backrest cover and padding, Cabriolet
• Removing locking pin · 1 torque figures