Removing and installing luggage compartment side trim — VW

🧭 Before you start

Fits: platform codes 121, BL1

• Renewed: if necessary

Don't miss

• Before installing, check all fasteners for damage and renew if necessary.Following installation, ensure that the trim is positioned in rear lid seal beading.

📋 Procedure

1. Remove rear shelf.
2. Remove rear seat backrest.
3. Remove side trim panel
4. Remove lower C-pillar trim.
5. Remove bolts (1).

6. Release luggage compartment side trim (1) from rear lid seal beading.
7. Release luggage compartment side trim (1) from mountings in area of locking lug (2) using removal wedge3409.
8. Release luggage compartment side trim (1) out of mountings in area of retaining clips (4) using wedge T10383.
9. Remove luggage compartment side trim (1). [Note: Before installing, check all fasteners for damage and renew if necessary.Following installation, ensure that the trim is positioned in rear lid seal beading.]
10. Insert centring pin (3) into mounting.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing reservoir for windscreen and headlight washer system (vehicles ▸ 10.00)
• Removing and installing left headlight range control motor V48 or right headlight range control motor V49 (vehicles ▸ 10.00)
• Removing and installing control unit for left gas discharge lamp J343 and/or control unit for right gas discharge lamp J344 (vehicles ▸ 09.00)
• Vehicles with 1.4 l 55 kW injection engine with manual gearbox
• Removing and installing reservoir for windscreen