Removing and installing lower front coolant pipe — AUDI

🧭 Before you start

Fits: VW Caddy IV (SA, 2015–2020)

• Renewed: seals

Don't miss

• Renew seals and O-rings after removal.Secure all hose connections with the hose clips corresponding to original equipment Electronic Parts Catalogue (ETKA).

🔧 Engine codes this applies to

📋 Procedure

1. Remove oil filter housing .
2. Remove air pipe .
3. Remove bolts (arrows).
4. Push bracket (1) with wiring harness to one side.
5. Remove throttle valve module J338.

6. Release clip (4).
7. Pull off coolant hose.
8. Remove bolts (arrows).
9. Pull off locking clip (2).
10. Pull thermostat housing (3) at bottom front off coolant pipe (1), and remove it.
11. Loosen clip (1).
12. Pull off coolant hose.
13. Remove bolt (4).
14. Pull off coolant pipe at bottom front (3), and remove it. [Note: Renew seals and O-rings after removal.Secure all hose connections with the hose clips corresponding to original equipment Electronic Parts Catalogue.]
15. Clean and smoothen sealing surfaces for seals and O-rings.
16. Lubricate seals and O-rings with coolant.
17. Replenish coolant .

Other AUDI procedures

• Removing and installing valve stem seals (cylinder head installed) · 1 torque figures
• Checking fuel delivery rate, engine codes CUUA, CUUB – VW CUUA
• Removing and installing emission control module, RHD vehicles
• Removing and installing high-pressure accumulator (rail) · 3 torque figures
• Checking exhaust gas recirculation cooler for leaks
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures