Removing and installing low-temperature radiator: Audi 2.0 (CADA, CAEB, CDNB, CDNC, …)

🧭 Before you start

Fits: platform codes SF, SG

• Renewed: o-rings

Don't miss

• If there are minor dents in the fins, refer to .
• If the radiator has been renewed, the entire coolant must be changed.

🔧 Engine codes this applies to

📋 Procedure

1. If fitted, remove engine cover panel .
2. If fitted, remove noise insulation General body repairs, exterior66Noise insulation; Removing and installing noise insulation.
3. Remove front bumper cover General body repairs, exterior63Front bumper; Removing and installing bumper cover.
4. Detach coolant hoses with clamps up to 25 mm3094.
5. Set drip tray for workshop hoistVAS 6208 underneath.

6. Release clips (1).
7. Pull off coolant hoses (2).
8. Remove front support element General body repairs, exterior63Front bumper; Removing and installing impact bar.
9. Unscrew bolts (1).
10. Release retainer (3).
11. Remove radiator (2). [Note: If there are minor dents in the fins, refer to .]
12. Renew O-rings after removal.
13. If the radiator has been renewed, the entire coolant must be changed.
14. Replenish coolant .

Other AUDI procedures

• Renewing timing chain cover (bottom)
• Draining and filling cooling system - vehicles with hybrid drive
• Exploded view - cylinder head (1.8 ltr. engine) · 3 torque figures
• Removing and installing cylinder head (2.0 ltr. engine without assembly clearance feature)
• Draining and filling cooling system - vehicles without hybrid drive
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures