Removing and installing front left chest vent temperature sensor G385 with a "“Low”" air conditioner (or with no air conditioner) — AUDI

🧭 Before you start

Fits: Audi A4 B9 (8W, 2015–)

Don't miss

• The air duct (B) is secured with 2 retaining clips (C) (left and right).

📋 Procedure

1. Move the front seats to the rearmost position.
2. Switch off the ignition.
3. Detach the right dash panel trim (A) with E87(B) from the dash panel General body repairs, interior70Dash panel; Exploded view - dash panel.
4. Unplug the connector from the front air conditioner operating and display unit E87Removing and installing front air conditioner operating and display unit E87.
5. Remove the right dash panel vent (broad band nozzle) (A)General body repairs, interior70Dash panel; Exploded view - dash panel.

6. Remove the air duct to the centre dash panel vents (B). [Note: The air duct (B) is secured with 2 retaining clips (C) (left and right).]
7. Reach into the dash panel opening and release and unplug the connector (A).
8. Give the sender (B) a 90° turn and remove it from the air duct (D).
9. Check the seal (C) for damage and proper attachment.
10. Interrogate the event memory of the front air conditioner operating and display unit E87 and erase any faults displayed "“Guided fault-finding”" mode.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing tank flap unit – Audi A3 1.8
• Removing and installing outer window slot trim strip – Audi
• Removing and installing cover for anti-theft system – Audi A3
• Removing and installing bumper cover (rear)
• Removing and installing starter - vehicles with 2.0 ltr. TDI engine