Removing and installing rear left chest vent temperature sender G635 — AUDI

🧭 Before you start

Fits: Audi A8 D4 (4H, 2010–2017)

📋 Procedure

1. Move the front left seat (driver's seat) as far forwards as it will go.
2. Switch off ignition.
3. Remove left rear seat or rear seat bench General body repairs, interior72Rear seats; Removing and installing seat bench / individual seats.
4. Remove left rear door sill panel trim General body repairs, interior70Passenger compartment trim panels; Removing and installing sill panel trim.
5. Remove lower B-pillar trim and left C-pillar trim General body repairs, interior70Passenger compartment trim; Removing and installing B-pillar trim, General body repairs, interior70Passenger compartment trim; Removing and installing B-pillar trim.

6. Carefully detach the rear left floor covering from the vehicle to provide access to G635(F) (fitted in the air duct to the rear left chest vent (G)).
7. Unplug the connector (E).
8. Turn the sender (F) through 90° and remove.
9. Check the seal (D) for damage and proper attachment.
10. Re-install all parts removed in reverse order.
11. Check that the trim panels for the footwell vents are installed in the proper position beneath the front seat.
12. Interrogate the event memory of the air conditioner front operating and display unit, Climatronic control unit J255 and the rear Climatronic operating and display unit E265 and erase any faults displayed in "“Guided Fault Finding”" mode.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing rain and light sensor G397, vehicles from 10.2012 onwards
• Removing and installing moulded headliner - vehicles with 3 doors
• Removing and installing moulded headliner - Sportback – Audi
• Removing and renewing camshafts or camshaft bearings - cylinder bank 2 (left-side)
• Renewing brake disc (1LM) · 1 torque figures