Removing and installing high-temperature radiator — AUDI

🔧 Engine codes this applies to

📋 Procedure

1. Move to service position General body repairs, exterior50Lock carrier; Moving to and back from service position.
2. Remove low-temperature radiator .
3. Detach coolant hoses with clamps up to 25 mm3094.
4. Set drip tray for workshop hoistVAS 6208 underneath.
5. Loosen clamps (1).

6. Pull off coolant hoses (2).
7. Pull off coolant hose (3).
8. Separate electrical connector (2).
9. Unscrew bolts (1).
10. Release clips (2).
11. Remove baffle plate (1).
12. Unscrew bolts (1).
13. Unclip lines (2) from guides (3).
14. Push down radiator mounting (4).
15. If fitted, remove adaptive cruise control unit J428Electrical system27Adaptive cruise control; Removing and installing adaptive cruise control unit.
16. Release locking lugs (1).
17. Pull out condenser (2) in direction of (arrow) from guides (3).
18. Hold condenser (1) to one side with aid of second mechanic.
19. Remove high-temperature radiator (2) in direction of (arrow). [Note: If there are minor dents in the fins, refer to .]
20. Renew O-rings after removal.
21. If the radiator has been renewed, the entire coolant must be changed.
22. Insert lower radiator mounting (1) in lock carrier (2).
23. Then turn lower radiator mounting 90°.
24. Replenish coolant .

Other AUDI procedures

• Removing and installing injector for reducing agent N474
• Removing and installing charge air cooling pump V188
• Coolant hose schematic diagram, vehicles with dual clutch gearbox, 2nd heat exchanger and supplementary heater
• Removing and installing high-temperature radiator
• Removing and installing toothed belt · 56 torque figures
• Removing engine · 41 torque figures
• Removing camshaft timing chain from camshafts · 38 torque figures
• Installing engine · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing head airbag - Saloon