Removing and installing front parking aid warning buzzer H22 - 8-channel parking aid — AUDI

🧭 Before you start

Fits: Audi Q7 (4L, 2005–2015)

Don't miss

• Unclip front parking aid warning buzzer H22(item 1) in direction of (arrow) from relay and fuse carrier in centre of dash panel.

📋 Procedure

1. Remove dash panel cover (top, driver's side) (repair group 68).
2. Release retaining clips (1) and (3) and swivel relay and fuse carrier in centre of dash panel downwards out of retaining frame (arrow).
3. Unscrew nut (4).
4. Release locking element (3) and disengage bracket for relay and fuse carrier in centre of dash panel from stud.
5. Press bracket for relay and fuse carrier in centre of dash panel slightly upwards to disengage retaining pin (1) at central tube.

6. Pull relay and fuse carrier in centre of dash panel out of body working from passenger compartment to disengage locking tab (2).
7. Take out relay and fuse carrier in centre of dash panel working from passenger compartment.
8. Unclip front parking aid warning buzzer H22(item 1) in direction of (arrow) from relay and fuse carrier in centre of dash panel.
9. Unplug electrical connector (2).
10. Install dash panel cover (top, driver's side) (repair group 68).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing brake pads (PR 1LK / 1LH), TTS
• Removing and installing vibration damper (1LK / 1LH), TTS · 1 torque figures
• Removing and installing drive shaft (right-side)
• Removing and installing front pressure hose sensor for pedestrian protection G579
• Renewing oil seal for output shaft – Audi A3