Removing and installing vibration damper (1LK / 1LH), TTS — AUDI
Removing and installing vibration damper (1LK / 1LH), TTS on Audi: 5 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code FV
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 10 Nm (7.4 lb-ft) | Insert vibration damper (arrow) and tighten bolt |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove bolt (arrow) for vibration damper.
- Remove vibration damper.
- Clean contact surface for vibration damper on brake caliper.
- Clean vibration damper.
- Insert vibration damper (arrow) and tighten bolt to 10 Nm. — 10 Nm (7.4 lb-ft)
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Adjusting convertible roof compartment lid
- Adjusting side window – Audi A4 Cabriolet B6/B7
- Separating refrigerant lines from condenser/connecting
- Removing and installing left footwell flap control motor V108
- Removing and installing retainers for left control motors (with a "“Mix”" or "“High”" air conditioner)
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.