Removing and installing front and rear cross members: Audi A8 D3
Step-by-step removing and installing front and rear cross members for the Audi A8 D3: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A8 D3 (4E, 2002–2010)
Don't miss
- Mark installation position of front cross member (1).
- Mark installation position of rear cross member (1).
📋 Procedure
- Mark installation position of front cross member (1).
- Remove bolts (2).
- Detach front cross member (1).
- Note correct position of front cross member (1).
- Tightening torque for bolts (2)
- Mark installation position of rear cross member (1).
- Remove bolts (2).
- Detach rear cross member (1).
- Note correct position of rear cross member (1).
- Tightening torque for bolts (2)
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Renewing oil seals for output shaft, "“self-locking”", "“0BU”"
- Repairing threaded electrical connections
- Removing and installing fresh air and air recirculation flap control motor V154 or air recirculation flap control motor V113
- Renewing seal between output flange bevel box, vehicles as of model year 2010
- TT_3.2 BHE/BPF Ancillary drive belt
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.