Renewing oil seals for output shaft, "“self-locking”", "“0BU”" — AUDI

🧭 Before you start

Fits: platform codes S1, 2H

• Renewed: oil seal

Don't miss

• The cover plate is destroyed during removal and must be renewed.
• Make sure not to cant the cover plate or the oil seal.

🔧 Engine codes this applies to

📋 Procedure

1. Remove front propshaft .
2. Using screwdriver, lift oil seal cover plate (1) all-round at several points.
3. Then, use a screwdriver, for example, to press off cover plate (1). [Note: The cover plate is destroyed during removal and must be renewed.]
4. Use a screwdriver to lift oil seal (1) at several points, and to push it out.
5. Half-fill space between sealing lip and dust lip (arrow) with sealing greaseElectronic Parts Catalogue.

6. Fit new oil seal on transfer box.
7. Push cover plate as far as possible onto output shaft.
8. Drive in new cover plate and oil seal to stop using thrust piece T10449. [Note: Make sure not to cant the cover plate or the oil seal.]
9. Install front propshaft .
10. Check oil in transfer box .

Other AUDI procedures

• Removing and installing oil pump – Audi A8 D3 · 5 torque figures
• Removing and installing transfer box – Audi Q7 ABCD
• Renewing propshaft flange seal – Audi ABCD
• Checking gear oil level – Audi Q3 ABCD
• Dismantling and assembling transfer box – Audi ABCD
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures