Renewing seal between output flange bevel box, vehicles as of model year 2010 — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T5 (7J), VW Transporter T6 (7E), VW Transporter T6 (7F)

• Special tools named: puller

Don't miss

• When pulling off output flange of bevel box with universal pullerKukko 18-1 , ensure that flange is not canted to prevent damaging dust cover (arrow).

📋 Procedure

1. Remove front propshaft. Propshaft39Removing and installing propshaft.
2. Remove circlip ring with appropriate circlip pliers.
3. Pull off output flange of bevel box with universal puller Kukko 18-1. [Note: When pulling off output flange of bevel box with universal pullerKukko 18-1 , ensure that flange is not canted to prevent damaging dust cover (arrow).]
4. Lever out seal using puller hooks T20143/2 .
5. Lightly oil new oil seal on outer diameter. Fill space between sealing lips (arrow) half full with sealing greaseElectronic Parts Catalogue.

6. Drive in oil seal without canting it, using thrust piece T10143.
7. Install output flange / bevel box together with dust seal.
8. Fit circlip.
9. Fit front propshaft tube. Propshaft and rear final drive39Final drive, rear differential.
10. Check / top up gear oil in bevel box .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures