Removing and installing exhaust gas recirculation control motor V338 - engine codes CAMA, CAMB, CAPA — AUDI

🧭 Before you start

Fits: Audi A5 (8T, 2007–2016), Audi A5 Cabriolet (8F), Audi A4 B8 (8K, 2007–2015)

• Opens: coolant
• Renewed: seals

Don't miss

• Disregard (arrow) on right-side of illustration.
• Disregard (item 2).
• Disregard (item 1).
• Renew seals and gaskets.

🔧 Engine codes this applies to

📋 Procedure

1. Drain coolant .
2. Remove engine cover panel (arrows).
3. Unscrew bolt (left arrow) and remove retaining clip.
4. Unscrew union nuts (1 ... 4) and detach high-pressure pipes. [Note: Disregard (arrow) on right-side of illustration.]
5. Remove union nuts (1) and (3), move high-pressure pipe clear and remove. [Note: Disregard (item 2).]

6. Remove intake manifold (top section) .
7. Remove oil filter housing .
8. Pull out retaining clip and detach connection (arrow) with thermostat for exhaust gas recirculation.
9. Detach electrical connector (2) for exhaust gas recirculation temperature sensor G98 from bracket and unplug. [Note: Disregard (item 1).]
10. Unplug electrical connector (arrow) for exhaust gas recirculation control motor V338.
11. Remove bolts (1, 2, 3), detach exhaust gas recirculation control motor V338 and detach from coolant hose (4). [Note: Renew seals and gaskets.]
12. Install oil filter housing .
13. Install intake manifold (top section) .
14. Install high-pressure pipes .
15. Fill up with coolant .

Other AUDI procedures

• Removing and installing mounting plate for engine oil cooler, pressure control valve and oil filter housing
• Removing and installing suction pipe
• Removing and installing turbocharger control unit J724
• Removing and installing coolant pipe (top right) – Audi A8 D3
• Removing and installing high-pressure pump - engine code CAPA
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures