Removing and installing delivery line — AUDI

🧭 Before you start

Fits: VW Caddy IV (SA, 2015–2020)

Don't miss

• Place a cloth underneath separating points to catch any escaping reducing agent.

🔧 Engine codes this applies to

📋 Procedure

1. Remove air filter housing .
2. Unscrew bolts (1).
3. Unclip air duct (2), and remove it.
4. If fitted, remove noise insulation General body repairs, exterior66Noise insulation; Removing and installing noise insulation. [Note: Place a cloth underneath separating points to catch any escaping reducing agent.]
5. Release plug-in connectors (1).

6. Seal off all open lines and connections with clean plugs from engine bung setVAS 6122.
7. Disconnect electrical connector (3).
8. Unclip deliver line (4) from retainers (2).
9. Remove delivery line (4).
10. If necessary, fill reducing agent 40Descriptions of work; AdBlue® (reducing agent).
11. Connect .
12. Switch ignition on.
13. Adapt SCR system learnt values , 01 - Systems capable of self-diagnosis, 01 - Diesel direction injection and preglow system EDC 17, 01 - Engine electronics functions, 01 - Adapting SCR system learnt values.
14. Follow further instructions displayed on .

Other AUDI procedures

• Assembly overview - sump/oil pump, vehicles with two-piece sump
• Removing and installing auxiliary pump for heating V488, version 2
• Removing and installing exhaust gas recirculation temperature sensor G98
• Removing and installing fuel pressure regulating valve N276, version 2
• Removing and installing fuel hoses in engine compartment, 6.0 bar low pressure fuel system
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures