Removing and installing CD changer - Roadster: Audi TT Mk1

🧭 Before you start

Fits: Audi TT Mk1 (8N)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off all electrical consumers.
2. Remove ignition key.
3. Remove left storage box: General Body Repairs, Interior70.
4. Remove clip in left storage compartment.
5. Slacken off remaining bolts (2) (2 Nm). — 2 Nm (1.5 lb-ft)

6. Unplug connector from CD changer.
7. Take CD changer out of left storage box.
8. Check CD changer adjustment
9. Installation is performed in reverse sequence.
10. After installation check wiring to radio .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Testing power supply relay for Motronic system – Audi 4.2 AHK
• Testing power output stages for ignition coils – Audi AEB/AHK
• Tightening torques
• Removing and installing ribbed belt
• Check solenoid valve for boost pressure limitation -N75