Removing and installing actuator for front air distribution flap (automatically controlled air conditioner) — AUDI

🧭 Before you start

Fits: platform code FV

Don't miss

• Check operation of flaps and hinge mechanism before installing.Make sure levers and shafts are seated correctly in actuator sockets.
• When fitting actuator, actuating lever (3) must engage in lever (4) of centre vent flap.

📋 Procedure

1. Remove dash panel General body repairs, interior70Dash panel; Removing and installing dash panel.
2. Remove air duct to centre defroster vent
3. Remove front air distribution flap control motor .
4. Carefully press off actuating lever (5)(arrow).
5. Remove bolts (1, 2 and 6).

6. Lift off actuator (7). [Note: Check operation of flaps and hinge mechanism before installing.Make sure levers and shafts are seated correctly in actuator sockets.]
7. Check that the two gear wheels are correctly positioned.
8. When fitting actuator, actuating lever (3) must engage in lever (4) of centre vent flap.
9. Install remaining components.
10. Interrogate event memory and erase any entries displayed; then perform "“Basic setting”" ("“Guided Fault Finding”").
11. As a final step, check operation of heater/air conditioner.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing radio
• Removing and installing bleeder connection
• Checking heating output (and activation of temperature flaps) - vehicles without air conditioner
• Removing and installing air quality sensor G238/humidity sender in fresh air intake duct G657
• Removing and installing bumper cover - Audi RS 3 – Audi A3