Removing and installing activated charcoal filter solenoid valve 1N80, vehicles with all engine codes except CFKA, CPMA, CPMB — AUDI

🧭 Before you start

Fits: Audi A5 Cabriolet (8F), Audi A5 (8T, 2007–2016), Audi A4 B8 (8K, 2007–2015)

🔧 Engine codes this applies to

📐 37 workshop diagrams for CABA

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Remove engine cover panel .
2. Remove throttle valve module J338.
3. Remove bolts (1, 2) and push bracket with electrical connectors to one side.
4. Unscrew bolt (2) and nut (1) for support for intake manifold.
5. Move electrical wiring harness clear and detach support for intake manifold.

6. Unplug following electrical connectors:
7. Unplug electrical connector (4).
8. Release hose clip (5) and detach vacuum line.
9. Unscrew bolt (3) and detach retaining clip.
10. Press release tabs on both sides and disconnect vacuum line (1) at intake manifold and at connection point (2).
11. Detach activated charcoal filter solenoid valve 1N80 from bracket and guide out vacuum line.
12. Install throttle valve module J338.
13. Install engine cover panel .

Other AUDI procedures

• Removing and installing Lambda probe after catalytic converter G130
• Exploded view - cylinder block (pulley end), vehicles with hydraulic power steering · 1 torque figures
• Checking fuel gauge sender 2G169 - A5 up to model year 2011, A4 up to model year 2012, rest-of-world vehicles with four-wheel drive, USA vehicles with front-wheel drive/four-wheel drive
• Checking intake manifold change-over function
• Removing and installing radiator fan V7 – Audi A6 C5
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures