Overview of fitting locations - hydraulic power steering (vehicles with 6-cylinder TFSI engine, vehicles with/without dynamic steering) — AUDI

🧭 Before you start

Fits: Audi A5 (8T, 2007–2016), Audi A5 Cabriolet (8F), Audi A4 B8 (8K, 2007–2015)

Don't miss

• Note correct position of line when connecting. Markings (1) and (2) must be aligned.

📋 Procedure

1. Secure bracket (2) to body with bolts (1).
2. Secure reservoir (4) in bracket (2) with bolt (3).
3. Fit reservoir (insert lug (1) into recess in bracket (2)).
4. Position hydraulic fluid cooler (1) on retainers (2) and then engage in retainers (3).
5. Bolt pressure line with nut (3) and rubber mounting (4) onto cross brace.

6. Note correct position of line when connecting. Markings (1) and (2) must be aligned.
7. Route pressure line (4) between connecting element (2) and engine mounting (3).
8. Screw retainer (5) to stud (1) with nut (6).
9. Fit clips (5) of return line (1) onto studs (2) on longitudinal member.
10. Insert return line (1) with colour markings (arrows) into clips (5).
11. Secure retainer (4) of return line (1) to front left of subframe (3).
12. Fit retaining plate of return line (1) onto studs of longitudinal member and tighten nuts (2).
13. Secure retainer (3) of return line (1) to front left of subframe.
14. Attach return line (4) with bracket (2) and bolt (1) to subframe (3).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing brake pads or linings
• Removing and installing axle beam, front-wheel drive
• Renewing desiccant bag for condenser, Caddy 2011 ►
• Removing and installing sill panel moulding
• Removing and installing aerial film for GSM/UMTS telephone in modular exterior mirror