Draining and filling high performance oil for Haldex coupling — AUDI

🧭 Before you start

Fits: platform codes SF, SG

Don't miss

• Risk of injuryWear acid-resistant gloves. — Position used oil collection and extraction unitV.A.G 1782 under final drive.

📋 Procedure

1. ⚠ Risk of injuryWear acid-resistant gloves. — Position used oil collection and extraction unitV.A.G 1782 under final drive.
2. Unscrew drain plug (arrow), and drain high-performance oil for Haldex coupling completely.
3. Renew oil seal (arrow) of drain plug.
4. Screw in drain plug and tighten to specified torque .
5. Place drip tray for workshop hoistVAS 6208 under rear final drive.

6. Remove oil filler plug (1).
7. Screw adapter6291/1-2(A) in to stop.
8. Engage elbow (B) in adapter (A).
9. Using filling deviceVAS 6291 A, add enough oil so that it runs out between the adapter of the filling device and the final drive housing.
10. Remove filling device and adapter; excess oil may still run out.
11. Renew oil seal (arrow) of oil filler plug.
12. Screw in oil filler plug (1) and tighten to specified torque .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking fuel filter
• Checking voltage supply and current consumption of fuel system pressurisation pump G6 engine codes BJB, BLS, BSU, BDJ, BST, BMM
• Checking voltage supply and current consumption of fuel supply pump G6, vehicles with 6.0 bar low pressure fuel system
• Removing and installing solenoids of fuel tank shut-off valves N361/N362/N363/N429/N430 · 1 torque figures
• Removing and installing upper toothed belt guard