Window drive mechanism - remove and install — VW
Window drive mechanism - remove and install on VW: 12 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Fox (5Z)
Don't miss
- Fasten glass activation mechanism to door with pop rivets; do not forget washers in this case.
- After assembling the door window glass, you must check the operation of the window drive mechanism.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 3.5 Nm (2.6 lb-ft) | Replace mountings (arrows |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove the front door lining General body repairs, interior70Lining / insulation
- Remove sealing membrane.
- Lower door window glass until the support is accessible on the window activation mechanism.
- Unlock locks (1) manually.
- Use a screwdriver to unlock the glass support in the window activation mechanism support. Turn the screwdriver to unlock.
- Loosen the glass support from the activation mechanism.
- Push the door's window glass up and immobilize it.
- Through the assembly opening, disconnect window activation motor of the window power activation mechanism.
- Drill pop rivets (1), lift the window activation mechanism from the couplings (2) and remove downward out through the assembly opening.
- Replace mountings (arrows). Fasten new mounting to 3.5 Nm. — 3.5 Nm (2.6 lb-ft)
- Fasten glass activation mechanism to door with pop rivets; do not forget washers in this case.
- After assembling the door window glass, you must check the operation of the window drive mechanism.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing centre console retainer, for all vehicles except e-Golf
- Removing and installing retaining plate for manually operated anti-dazzle interior mirror, with rain and light sensor G397 and without front camera for driver assist systems R242
- Removing and installing seat height adjustment, standard seat, seat of type "ergo Aktiv"
- Removing and installing seal for sliding sunroof frame – VW
- Removing and installing misfuelling prevention device
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.