Wheel bearing set - remove and install — VW

🧭 Before you start

Fits: platform codes 6A1, 6A5

📋 Procedure

1. Loosen the wheel bolts.
2. Raise the vehicle.
3. Disassemble the wheel.
4. Lift the brake.
5. For such, press the wedge upwards through a brake drum orifice, using a screwdriver.

6. Remove the bolt (1) and remove the brake drum (2).
7. Remove the dust cover from its position by slightly tapping the claw on the hub cover pullerVW 637/2(1).
8. Press the dust cover.
9. loosen the twelve-point nut (1).
10. Remove the wheel bearing set/wheel hub (2) from the axle pin.
11. Carefully push the wheel bearing set/wheel hub (2) into the axle pin.
12. Screw in a new twelve-point nut (1) and tighten to the indicated tightening torque.
13. Install the new dust cover, using the pressure part3456(1) .
14. Install the wheel and tighten .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing central flap control motor V70 – VW · 2 torque figures
• Removing and installing oil supply line – VW 1.9 TDI
• Removing and installing subframe with steering rack, electromechanical steering
• Removing and installing tensioning bar – VW Golf Cabriolet · 2 torque figures
• Removing and installing oil reservoir – VW Golf Cabriolet · 2 torque figures