Removing and installing oil reservoir: VW Golf Cabriolet

🧭 Before you start

Fits: VW Golf Cabriolet (517, 2011–2016)

Don't miss

• Always install new seals.The fluid reservoir can only be installed in a certain position relative to the pump body.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove hydraulic pump
2. Open bypass screw (4).
3. Loosen bolt (3).
4. Pull off fluid reservoir (1).
5. Close bypass screw (4). [Note: Always install new seals.The fluid reservoir can only be installed in a certain position relative to the pump body.]

6. Open bypass screw (4).
7. Push on new seal (2).
8. Push on fluid reservoir (1) fully.
9. Tighten bolt (3). Torque setting: 6 Nm. — 6 Nm (4.4 lb-ft)
10. Close bypass screw (4). Torque setting: 2 Nm. — 2 Nm (1.5 lb-ft)
11. Check fluid level and replenish as necessary

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Checking throttle valve
• Removing and installing anti-roll bar, vehicles with power steering
• Removing and installing wheel bearing/hub unit on vehicles with drum brakes
• Removing middle sun visor – VW Polo 9N · 1 torque figures
• Removing front belt buckle – VW Polo 9N · 1 torque figures