Tailgate - adjust — VW

🧭 Before you start

Fits: platform codes 5W9, 5W1, 5W5

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove the tailgate protector .
2. Remove the locking control from the cargo compartment cover .
3. Remove the tailgate handle .
4. Remove the tailgate lock .
5. Remove rear protector (central).

6. Remove the tailgate damper .
7. Remove tailgate .
8. When assembling, apply sealant/caulking to the tailgatePaint Manual - Body Sealant.
9. Paint the tailgate Paint Manual - Repairing paintwork on steel plates and galvanized steel plates.
10. Apply anti-corrosive fluid Paint Manual - Application of Anti-corrosive fluid - Anti-corrosive fluid.
11. Install tailgate .
12. Install the tailgate lock .
13. Install the tailgate handle .
14. Install the locking control from the cargo compartment cover .
15. Install the tailgate protector.
16. Install the tailgate damper .
17. Install rear protector (central).
18. Adjust tailgate .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Checking the fuel delivery rate of the fuel pump for delivery G6 (0.5 bar low-pressure fuel system)
• Removing and installing engine control unit J623, engine control unit with protective housing
• Rear wheel brake (One shot (wedge) system) - assembly overview
• Checking switchover of intake manifold flap – VW 2.8 TDI AUH
• Checking signals from/to air conditioner – VW 2.8 TDI AUH/BCQ