2nd and 4th gear brake -B2-: adjust — VW
2nd and 4th gear brake -B2-: adjust on VW: 4 steps, 2 torque figures. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 45 Nm (33 lb-ft) | Tighten the nut (1) to the torque |
| 5 Nm (3.7 lb-ft) | Tighten the setscrew (2) to the torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Assemble the components necessary to adjust the 2nd and 4th gear brake -B2-
- Tighten the setscrew (2) to the torque of 5 Nm. — 5 Nm (3.7 lb-ft)
- Release the screw 2.5 turns.
- Tighten the nut (1) to the torque of 45 Nm. When doing so, immobilize the screw so it does not turn. — 45 Nm (33 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Checking the fuel pump V393 or fuel pump 2 V277 (Inline EKP) CFFA, CFFB
- Removing and installing steering column electronics control unit J527 (manufacturer: Valeo)
- Assembly overview of park assist steering
- All-wheel drive - repairing clutch housing
- Assembly overview - removing and installing gearbox housing and selector mechanism
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix → · How these pages are made →Workshop data on this page last updated 20 Sep 2026.