StarterB for vehicles with 1.4l engine (BAY) — VW
StarterB for vehicles with 1.4l engine (BAY) on VW: 13 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 9A2, 9A4, 9A5, 9A1, 9A3, 9A6
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 15 Nm (11 lb-ft) | Loosen the securing nut (2 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Turn off the ignition, all the electrical devices, and remove the key from ignition.
- Disconnect the BatteryA.
- Put the vehicle on a lift in order to make the operation easier.
- Remove engine cover panel in the direction of the (arrows).
- Disconnect terminal 50 (1) from StarterB.
- Release the securing nut (2) and remove the positive wire.
- Loosen securing nut (arrow) and remove the ground strap.
- Loosen the upper fastening screw (arrow) for the StarterB.
- Remove the lower engine noise insulation General body repairs, exterior50Body - front part.
- Loosen the securing nut (2) (15 Nm) and remove the support (2). — 15 Nm (11 lb-ft)
- Loosen the lower fastening screw (arrow) for the StarterB.
- Remove the StarterB.
- Tighten the fastening screws and nuts of the StarterB with the specified tightening torque .
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- 5-speed manual gearbox 02C, four-wheel drive — Renewing flange shaft oil seals (final drive installed)
- Removing and installing alarm horn H12, vehicles for Australia · 1 torque figures
- Removing and installing radiator cowl with radiator fan, CC
- Removing and installing arm rest – VW Polo 6R · 1 torque figures
- Removing and installing mounting parts for variable luggage compartment floor · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.