Starter B (vehicles with 09G automatic transmission) - remove and install — VW

🧭 Before you start

Fits: platform codes 9B1, 9B3

Don't miss

• The fastening nut for the harness support is located below the same
• There may be variation of positioning of the fastening screw, depending on the version.

📋 Procedure

1. Turn off the ignition, all the electrical devices, and remove the key from ignition.
2. Disconnect the BatteryA .
3. Remove the lower engine noise insulation General body repairs, exterior50Body - front part.
4. Remove the side noise insulation (left side) from the engine compartment by releasing the hex nut and detaching the fastening clips (arrows).
5. Move aside the power steering rigid tube support from the hydraulic steering and disconnect the connector(arrow).

6. Remove the plastic cover (1) , then release the ground cable fastening nut and remove the cable.
7. Disconnect connector (2) from the magnetic key for the StarterB.
8. Release the fastening nut for the harness support and move it away from the StarterB. [Note: The fastening nut for the harness support is located below the same]
9. Remove the upper fastening screw (1) then the lower screw (2) from the StarterB. [Note: There may be variation of positioning of the fastening screw, depending on the version.]
10. Tighten the fastening nuts to the specified torque.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Code letters, gearbox allocation, ratios, capacities
• Removing and installing tandem pump · 4 torque figures
• Removing and installing engine control unit – VW Jetta VI · 3 torque figures
• Disconnecting and reconnecting battery, vehicles with one-battery concept · 4 torque figures
• Removing and installing rear centre console trim – VW · 5 torque figures