Safety belt height regulator (2 and 4 doors) - removal and installation — VW

🧭 Before you start

Fits: VW Fox (5Z)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove the belt guide .
2. Remove B-pillar upper lining .
3. Remove the belt guide .
4. Remove B-pillar upper lining .
5. Remove securing bolts (1).
6. Remove the belt height regulator (2) from column B.
7. Tighten securing bolts (1) to (23 Nm) torque. — 23 Nm (17 lb-ft)

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing activated charcoal filter (engine codes CBTA, CBUA, BGP, BGQ)
• Checking fuel tank breather (engine codes CAVA, CAVB, CAVC, CAVD)
• Removing and installing engine control unit (Golf) – VW BJB
• Removing and installing seat cover and seat cushion for "“1/3”" bench seat (5-seater)
• Checking voltage supply of fuel pump G6, engine codes CFFA, CFFB, CFGB, CLLA