Routing tensioning strap 1 — VW

🧭 Before you start

Fits: platform code 1F7

Don't miss

• All bolts are microencapsulated and must always be renewed.Specified torque for bolts: 3 Nm.

📋 Procedure

1. Open roof using convertible top actuation switch until rear lid with rear shelf is swung open.
2. Open the bypass valve on the hydraulic pump.
3. Position hinge supportsVAS 6365 in centre position (2).
4. Secure hinge supportVAS 6365 on locking device of rear window frame (1).
5. Lower rear window frame until supports (4) sit on longitudinal member (5). [Note: All bolts are microencapsulated and must always be renewed.Specified torque for bolts: 3 Nm.]

6. Secure eye (2) to rearmost guide rail. Eye is aligned parallel to outer edge of guide rail.
7. Secure eye (3) to guide spring on hinge of rear window frame.
8. Secure eye (4) to guide spring on arm of hinge for rear window frame.
9. From interior, secure eye (5) to foremost arm of hinge for rear window frame. Eye is aligned parallel to edge of arm.
10. Secure end eye (6) to rearmost arm of hinge for rear window frame. Eye is aligned vertically upwards.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing engine control unit (Golf) – VW BJB
• Removing and installing seat cover and seat cushion for "“1/3”" bench seat (5-seater)
• Checking voltage supply of fuel pump G6, engine codes CFFA, CFFB, CFGB, CLLA
• Removing and installing headlight dipped beam bulb M29/M31
• Removing and installing tail light MX5/MX6, rear lid, Estate