Removing and installing windscreen washer reservoir (single chamber version) — VW

🧭 Before you start

Fits: VW Passat B6 (3C, 2005–2010)

Don't miss

• Depending on equipment fitted, there may be a requirement to release retainers for pipework blocking access to securing bolt (2).
• When installing window washer system reservoir, ensure that lines in the vicinity of the reservoir are not squashed and are clipped back into their original position on the reservoir.

📋 Procedure

1. Switch off ignition and all electrical consumers and disengage ignition key or start button by moving to position 0 (pre-detent).
2. Remove front bumper cover General body repairs, exterior63Removing and installing front bumper.
3. Remove front right wheel housing liner General body repairs, exterior66Removing and installing wheel housing liner.
4. Remove right headlight .
5. Place lock carrier in service position General body repairs, exterior50Lock carrier.

6. Unscrew fuel filter bracket and place filter to side with lines still connected.
7. Unclip all lines from reservoir for windscreen and headlight washer systems.
8. Remove securing bolt (1).
9. Remove securing bolt (2). [Note: Depending on equipment fitted, there may be a requirement to release retainers for pipework blocking access to securing bolt (2).]
10. Remove securing bolt (5) from wheel housing.
11. Pull hose connection off washer pump V5(3) and collect escaping washer fluid in a suitable container.
12. Release and disconnect connector on washer pump V5(3).
13. Remove window washer system reservoir (4) from vehicle upwards. [Note: When installing window washer system reservoir, ensure that lines in the vicinity of the reservoir are not squashed and are clipped back into their original position on the reservoir.]
14. Tighten all threaded connections to specified torque .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Dismantling and assembling differential, front-wheel drive
• Removing and installing gear knob, CC
• Removing and installing selector cable, - gear lever is NOT "“pushed down”" to engage reverse gear
• Removing and installing windscreen wiper motorV
• Removing and installing windscreen wiper arm