Removing and installing gear knob, CC — VW

🧭 Before you start

Fits: VW CC (358, 2012–2017)

📋 Procedure

1. Open ash tray.
2. Press hook for front end 3370 as far as it will go under the plastic frame for the gaiter (arrow 1).
3. Pull gaiter with plastic frame out of centre console frame (A)(arrow 1).
4. Hold frame in position.
5. Pull gaiter upwards, inside out over gear knob.

6. Open clamp (arrow) and pull off gear knob together with gaiter.
7. If noise insulation is present, pull it off.
8. If fitted, first insert noise insulation.
9. Then push frame into centre console.
10. Then turn gaiter inside out.
11. Install gear knob and gaiter and squeeze new clamp (arrow) together.
12. Insert back of gaiter with plastic frame first.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing defroster flap control motor V107/temperature flap control motor V68, RHD vehicles
• Removing and installing camshaft adjuster for inlet camshaft
• Renewing crankshaft oil seal, belt pulley end
• Removing and installing inner constant velocity joint
• Removing and installing wheel hub with wheel bearing