Removing and installing defroster flap control motor V107/temperature flap control motor V68, RHD vehicles — VW

🧭 Before you start

Fits: VW Polo 6C (2014–2017)

Don't miss

• Take note of narrower tooth on each lever segment and the resulting larger gap between the teeth at this position.
• If gear wheels and levers are not aligned as prescribed, the control motor will lock up as soon as a wide tooth attempts to mesh with a narrow tooth.
• If the gear wheels and levers are not aligned, the control motors will lock up, or the heater and air conditioning unit will be noisy as the flaps will not close correctly.

📋 Procedure

1. Remove heater and air conditioning unit (see the separate procedure).
2. Remove distribution box from heater and air conditioning unit.
3. Pull connectors (A) and (B) off control motors.
4. Release catches (C) and (D).
5. Pull bracket with control motors out of mountings (E).

6. Position control motor gear wheels (C) and (E) as illustrated.
7. Use adapter cable (A) for this purpose (see the separate procedure).
8. Position levers (A) (defroster flap) and (B) (temperature flap) on air distribution housing as illustrated. [Note: Take note of narrower tooth on each lever segment and the resulting larger gap between the teeth at this position.]
9. Insert control motor bracket into mounting (E).
10. Join defroster flap control motor V107(B) with lever (A) and temperature flap control motor V68(D) with lever (C). Ensure gear wheels are properly aligned with levers. [Note: If gear wheels and levers are not aligned as prescribed, the control motor will lock up as soon as a wide tooth attempts to mesh with a narrow tooth.]
11. Engage bracket on air distribution housing (C) and (D).
12. Check function of control motors. Connect 12 V source to contacts (4) and (6) using adapter cable (A) for control motors and check function of control motors. Check each control motor individually! [Note: If the gear wheels and levers are not aligned, the control motors will lock up, or the heater and air conditioning unit will be noisy as the flaps will not close correctly.]

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Assembly overview - brake booster/brake master cylinder (right-hand drive vehicle)
• Assembly overview - clutch hydraulics, right-hand drive
• Assembly overview - clutch
• Assembly overview - gearbox housing and clutch housing
• Rear suspension (Gol and Voyage) - assembly overview