Removing and installing camshaft adjuster for inlet camshaft — VW

🧭 Before you start

Fits: VW Golf VII Variant (BA), VW Polo 6C (2014–2017), VW Golf Sportsvan (AM1, 2014–2020), VW Golf VII (5G, 2012–2020)

• Timing position: the crankshaft or camshaft is set and locked during this job

🔧 Engine codes this applies to

📋 Procedure

1. Set engine to "“TDC for cylinder no. 1”".
2. Detach toothed belt from camshafts .
3. Use counter-hold tool T10554 and counter-hold tool T10172 to prevent camshaft from turning (push »anti-clockwise«).
4. Unscrew bolt (2) for camshaft adjuster of inlet camshaft.
5. Remove camshaft adjuster of inlet camshaft.

6. Install camshaft adjuster.
7. Renew bolts (1) and (2) for camshaft adjusters, and screw them in loosely.
8. Centre marks (3) of inlet camshaft pulley (1) relative to web (2) on camshaft housing.
9. Centre marks (3) of exhaust camshaft pulley (1) relative to web (2) on camshaft housing.
10. Insert assembly tool T10476A between camshaft pulleys.
11. Insert assembly tool T10476A to stop.
12. Adjusting valve timing .

Other VW procedures

• Removing and installing oil level and oil temperature sender G266 · 1 torque figures
• Draining fuel tank - vehicles with four-wheel drive – Audi A1
• Removing and installing toothed belt pulley for coolant pump
• Removing and installing thermostat for large cooling circuit
• Removing and installing thermostat for large cooling circuit
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures