Removing and installing vane pump, 10-cylinder diesel engine — VW

🧭 Before you start

Fits: VW Touareg I (7L, 2002–2010)

• Opens: power steering fluid

📋 Procedure

1. Clamp suction hose with hose clamp3094.
2. Remove engine with gearbox 10-cylinder diesel engine10Removing and installing engine.
3. Remove air conditioning compressor Heating, air conditioning system87Air conditioning compressor.
4. Unbolt turbocharger pipe from cylinder block (arrow).
5. Unbolt turbocharger pipe from turbocharger (arrows) and lay to side.

6. Unscrew pressure line from vane pump.
7. Seal pressure line using plastic bag or suitable alternative.
8. Disconnect suction line from vane pump.
9. Unbolt vane pump from cylinder block.
10. Fill vane pump with hydraulic fluid. Fill vane pump with fluid through intake connecting piece.
11. Turn hub by hand until fluid exits from pressure side.
12. Install vane pump.
13. Bleed steering system .
14. Check hydraulic fluid level 17.1Power steering: check hydraulic fluid level.
15. Check steering system for leaks .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing exhaust gas recirculation cooler, engine code CRVA
• Removing and installing bracket for roof grab handle – VW · 1 torque figures
• Removing and installing rear 3-point seat belt, estate, with belt tensioner
• Installing front differential lock – VW Golf VII
• Removing and installing front side window – VW Touran II