Removing and installing tail light in rear lid, Saloon — VW

🧭 Before you start

Fits: platform codes AU1, BX5

Don't miss

• Danger of damage to component surfaces.When using leverage tools, mask visible areas of the component with commercially available adhesive tape. — If necessary, fit a narrow screwdriver at opening on side.

📋 Procedure

1. Switch off ignition and all electrical consumers.
2. Remove ignition key, if inserted.
3. ⚠ Danger of damage to component surfaces.When using leverage tools, mask visible areas of the component with commercially available adhesive tape. — If necessary, fit a narrow screwdriver at opening on side.
4. Press off cover (1) in (direction of arrow).
5. Release connector (2) and disconnect.

6. Remove nuts (1).
7. Remove left tail light 2MX5(3) outwards.
8. Swing left tail light 2MX5 from the outside into rear lid opening.
9. Align it properly to make contact at top and centre.
10. Screw on nuts first at top and then at bottom of left tail light 2MX5 and tighten them.
11. Test functionality.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing voltage stabiliser J532, left-hand drive vehicles · 2 torque figures
• Checking and adjusting selector lever cable, vehicles up to 05.2012 · 1 torque figures
• Removing and installing motor/pump unit – VW Polo 6R CLPA/CLSA
• Removing and installing alternator, 1.6 l, 66/77 kW TDI engine
• Removing and installing Haldex coupling pump V181, generation V · 1 torque figures