Removing and installing tail light in rear lid, estate — VW

🧭 Before you start

Fits: platform codes AU1, BX5

Don't miss

• Danger of damage to component surfaces.When using leverage tools, mask visible areas of the component with commercially available adhesive tape. — If necessary, fit a narrow screwdriver on side opening (1).
• Ensure that the gap between vehicle body and tail light housing is properly sealed by the seal.Make sure that the connector is engaged firmly.

📋 Procedure

1. Switch off ignition and all electrical consumers.
2. Remove ignition key, if inserted.
3. ⚠ Danger of damage to component surfaces.When using leverage tools, mask visible areas of the component with commercially available adhesive tape. — If necessary, fit a narrow screwdriver on side opening (1).
4. Press off cover (2) in direction of arrow (A).
5. Disconnect electrical connector (2).

6. Remove nuts (1).
7. Remove left tail light 2MX5(3) outwards. [Note: Ensure that the gap between vehicle body and tail light housing is properly sealed by the seal.Make sure that the connector is engaged firmly.]
8. Swing left tail light 2MX5 from the outside into rear lid opening.
9. Align it properly to make contact at top and centre.
10. Screw on nuts first at top and then at bottom of left tail light 2MX5 and tighten them.
11. Test functionality.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing toothed belt, tensioning roller A · 6 torque figures
• Removing and installing turbocharger · 7 torque figures
• Removing and installing unit injector – VW Golf IV / Bora · 9 torque figures
• Removing and installing toothed belt (for vehicles ► 05.05) · 6 torque figures
• Adjusting differential – VW Sharan I / SEAT Alhambra · 10 torque figures