Removing and installing tail light in rear lid: VW Golf VII

🧭 Before you start

Fits: VW Golf VII (5G, 2012–2020)

Don't miss

• Danger of damage to component surfaces.When using leverage tools, mask visible areas of the component with commercially available adhesive tape. — If needed, apply a narrow screwdriver at opening on side.
• Ensure that the gap between vehicle body and tail light housing is properly sealed by the seal.Make sure that the connector is engaged firmly.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Turn light switch to "“0”" position.
2. ⚠ Danger of damage to component surfaces.When using leverage tools, mask visible areas of the component with commercially available adhesive tape. — If needed, apply a narrow screwdriver at opening on side.
3. Press off cover (1) in (direction of arrow).
4. Remove nuts (1).
5. Disconnect electrical connector (2).

6. Remove left tail light 2MX5(3) outwards. [Note: Ensure that the gap between vehicle body and tail light housing is properly sealed by the seal.Make sure that the connector is engaged firmly.]
7. Swing left tail light 2MX5 from the outside into rear lid opening.
8. Align it properly to make contact at top and centre.
9. Screw on nuts first at top and then at bottom of left tail light 2MX5 and tighten them.
10. Test functionality.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures