Removing and installing steering column switch, vehicles 10.99 ▸ — VW
Removing and installing steering column switch, vehicles 10.99 ▸ on VW: 12 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code 6N1
📋 Procedure
- Disconnect battery .
- Remove driver airbag General body repairs, interior69Airbag; Removing and installing driver airbag▸.
- Remove cross-head screws (1).
- Remove Torx bolt (2).
- Remove lower trim (3) and side trim (4) for steering column switch.
- Detach connector (arrow) from resetting unit.
- Remove steering wheel General body repairs, interior69Airbag; Removing and installing steering wheel 10.99 ▸.
- Detach upper steering column trim (1).
- Remove securing bolts (arrows).
- Disconnect connectors (arrows) from steering column switch.
- Remove connector housing (1) downwards out of guide on steering lock housing.
- Remove steering column switch.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing O-rings for unit injector – VW Polo 9N
- Removing and installing steering column switch and steering lock housing with ignition switch, vehicles ▸ 05.00
- Adjusting output shaft for 1st through 4th gears – VW 2.0
- Generator (Alternator)C for 1.6l (CCRA) engine - remove and install
- Generator (Alternator)C for 1.4l (BAY) engine - remove and install
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.