Removing and installing starter, vehicles with 1.8 l, 118 kW TSI engine with manual gearbox MQ200-6F — VW

🧭 Before you start

Fits: VW Golf VI (5K, 2008–2013)

📋 Procedure

1. Disconnect battery .
2. Remove air filter housing Engine mixture preparation24Repairing injection system; Removing and installing air filter.
3. Slide protective cap in direction of (arrow) off solenoid switch.
4. Unscrew positive wire (1) and disconnect connector from terminal 50 (2).
5. Unscrew securing nut (arrow) and remove earth cable from the upper securing bolt on starter.

6. Remove upper securing bolt of starter (arrow).
7. Remove noise insulation General body repairs, exterior50Body - front; Noise insulation.
8. Remove nut (1) from lower securing bolt of starter.
9. Remove wiring retainer (2).
10. Remove lower securing bolt of starter (arrow).
11. Remove starter.
12. Tighten threaded connections to torques specified in assembly overview .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing bearing saddle for crankshaft – VW AJS · 4 torque figures
• Removing engine, Golf, Golf Plus, Scirocco – VW 2.0 TDI
• Removing and installing side trim panel, Cabriolet · 3 torque figures
• Removing and installing alternator, 2.0 l TDI unit injector engine · 3 torque figures
• Removing and installing supercharger (Tiguan with four-wheel drive)