Removing and installing starter, 1.4 l, 90 kW TSI engine with manual gearbox MQ200-6F — VW

🧭 Before you start

Fits: VW Golf VI (5K, 2008–2013)

📋 Procedure

1. Disconnect battery (see the separate procedure).
2. Remove air filter housing Engine mixture preparation 24. Repairing injection system; Removing and installing air filter.
3. Release and disconnect connector (1).
4. Slide protective cap (1) off solenoid switch in direction of (arrow).
5. Unscrew securing nut (1) and remove positive wire (2) from connector thread of solenoid switch.

6. Unscrew nut (1) from upper securing bolt of starter and remove earth cable (2).
7. Unscrew upper securing bolt of starter that is located behind.
8. Remove noise insulation General body repairs, exterior 50. Body - front; Noise insulation.
9. Unscrew nut (1) and remove cable holder (2) from bottom securing bolt of starter.
10. Unscrew lower securing bolt (2) off starter.
11. Remove starter (1) downwards from vehicle.
12. Tighten threaded connections to torques specified in assembly overview (see the separate procedure).

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Install calculated shims as follows: – VW Passat B5
• Removing and installing starter, vehicles with 3.2 l, 177 kW injection engine, automatic gearbox AL420-6Q
• Renewing left gas discharge bulb L13 and right gas discharge bulb L14 for dipped beam
• Vehicles with 1.4 l 63 kW FSI engine and manual gearbox
• Vehicles with a 1.4 l injection engine and automatic gearbox