Vehicles with 1.4 l 63 kW FSI engine and manual gearbox — VW

📋 Procedure

1. Disconnect battery (see the separate procedure).
2. Release and disconnect terminal 50 connector (1).
3. Pull plastic cap (2) off.
4. Remove the securing nut behind this and disconnect wire (3) from solenoid-operated switch/terminal (repair group 30).
5. Remove securing nut (5) from upper starter securing bolt.

6. Disconnect earth wire (4) and remove the upper starter securing bolt behind this.
7. Remove noise insulation General body repairs, exterior 50. Body - front.
8. Remove securing nut (1) from lower starter securing bolt (2).
9. Remove bracket (3).
10. Remove lower securing bolt (2) on starter and remove starter from vehicle.
11. Tighten all threaded connections to the specified torques (value given in the factory table, not available here).
12. Reconnect battery (see the separate procedure).

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing expansion valve, e-Golf with heat pump
• Removing air conditioner compressor from and installing to bracket, Passat GTE
• Removing and installing air conditioner compressor, Passat
• Removing and installing metering pump V54, Passat
• Removing and installing rear lid lock with power latching system