Removing and installing starter, 2.5 l injection engine, automatic gearbox AQ250-6F — VW

🧭 Before you start

Fits: VW Golf VI (5K, 2008–2013)

📋 Procedure

1. Disconnect battery .
2. Release and disconnect connectors (1) and (2).
3. Unfasten spring-type clip (3) and remove air hose.
4. Remove both securing bolts (arrows).
5. Lift engine cover with air filter up (arrows) and remove from vehicle.

6. Slide protective cap in direction of (arrow) off solenoid switch.
7. Unscrew positive wire (1) and disconnect connector from terminal 50 (2).
8. Remove nut (1) from upper securing bolt of starter.
9. Remove wiring retainer (2).
10. Remove upper securing bolt of starter (arrow).
11. Remove noise insulation General body repairs, exterior50Body - front; Noise insulation.
12. Remove nut (1) from lower securing bolt of starter.
13. Remove wiring retainer (2).
14. Remove lower securing bolt of starter (arrow).
15. Remove starter downwards out of vehicle.
16. Tighten threaded connections to specified torques.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing alternator, vehicles with 3.6 l petrol engine
• Removing and installing brake pads, front brakes FNR-G – VW
• Removing and installing brake caliper, front brake FN3 – VW
• Checking delivery pressure of fuel system pressurisation pump G6, engine code CFHC
• Removing and installing over-centre spring, Golf, Golf Estate