Removing and installing starter, 2.0 l diesel engine, 81/103 kW, manual gearbox — VW

🧭 Before you start

Fits: VW Jetta VI (16, 2010–2018)

📋 Procedure

1. ⚠ When disconnecting or reconnecting the batteryA, adhere strictly to the procedure described in the workshop manual (see the separate procedure). — Disconnect batteryA.
2. Remove engine cover 10Engine cover ; Removing and installing engine cover (see the separate procedure).
3. Remove air filter housing 23Air filter; Removing and installing air filter housing.
4. Pull protective cap off solenoid switch in (direction of arrow).
5. Unscrew positive cable (1) and release and detach connector (terminal 50) (2).

6. Unscrew and remove earth wire from starter bolt (arrow).
7. Unscrew starter bolt (arrow).
8. Remove noise insulation General body repairs, exterior 66. Noise insulation; Assembly overview - noise insulation.
9. Undo nut (1) and remove it from lower securing bolt of starter.
10. Remove wire holder (2).
11. Unscrew starter bolt (arrow).
12. Remove starterB.
13. Tighten threaded connections to specified torque (value given in the factory table, not available here).
14. Reconnect batteryA.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Fitting tyre to wheel rim – VW CLPA/CLSA
• Adjusting front axle toe – VW Sharan II / SEAT Alhambra CLPA · 1 torque figures
• Removing and installing engine control unit with protective housing, Sharan
• Removing and installing fuel delivery unit/fuel gauge sender, right side
• Removing and installing right dash panel facing trim, driver side · 1 torque figures