Adjusting front axle toe: VW Sharan II / SEAT Alhambra (CLPA, CLSA)
Step-by-step adjusting front axle toe for the VW Sharan II / SEAT Alhambra (CLPA/CLSA): 6 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Sharan II / SEAT Alhambra (7N, 2010–)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 50 Nm (37 lb-ft) | Tighten lock nut (1) |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Loosen lock nut (3) while counterholding on head of track rod (2).
- Pull spring-type clip (1) off boot.
- Adjust toe by turning left and/or right track rod.
- Tighten locknut with tool insert 24 mmV.A.G 1332/11 while counterholding track rod ball joint (1).
- Check toe values again.
- Fit spring-type clip to boot.
Other VW procedures
- Removing and installing steering column, right-hand drive vehicle
- Removing and installing camshaft housing
- Removing and installing engine control unit J623 with protective housing · 1 torque figures
- Removing and installing steering column, left-hand drive vehicle
- Removing and installing bonded rubber bush – VW Polo 6R CLPA
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.