Adjusting camber on rear axle — VW

🧭 Before you start

Fits: platform code 6Z1

Don't miss

• The maximum adjustment range is 90° to the left or right of centre.

📋 Procedure

1. Raise vehicle 37.1General information; Raising vehicle.
2. Remove wheel housing liner General body repairs, exterior66Wheel housing liner; Removing and installing front wheel housing liner.
3. Remove rear underbody cover General body repairs, exterior66Underbody cover; Removing and installing underbody covers.
4. Unscrew nut (1) of eccentric bolt (2) from suspension link (3).
5. Tighten new nut (1) for eccentric bolt (2) hand-tight.

6. Adjust camber by turning eccentric bolt (2) in direction of (arrows) until specified value is obtained. [Note: The maximum adjustment range is 90° to the left or right of centre.]
7. Tighten nut of eccentric bolt(1) hand-tight.
8. Check camber value.
9. Remove wheel .
10. Tighten nut (1) of eccentric bolt (2).

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Renewing seal for propshaft output flange on bevel box – VW
• Removing and installing high-voltage battery charging socket 1UX4
• Removing and installing brake system pressure accumulatorVX70, RHD vehicles
• Removing and installing selector mechanism without selector lever cable, Passat 2015 ►, Passat Variant 2015 ►
• Removing and installing high-voltage battery charging socket 1UX4, AC charging socket