Removing and installing starter, 2.0 l, 195/188 kW TSI engine with manual gearbox (MQ350-6F) — VW

🧭 Before you start

Fits: platform code 137

📋 Procedure

1. Disconnect battery .
2. Remove securing bolts (2).
3. Loosen spring-type clips (1) using spring-type clip pliersVAS 5024 A and push spring-type clips on engine cover panel.
4. Remove intake hose (3).
5. Slide protective cap in direction of (arrow) off solenoid switch.

6. Unscrew positive wire (1) and disconnect connector from terminal 50 (2).
7. Unscrew earth wire from securing bolt of starter (arrow).
8. Remove upper securing bolt of starter (arrow).
9. Remove noise insulation General body repairs, exterior50Body - front; Noise insulation.
10. Remove securing nut (1) from lower securing bolt of starter.
11. Remove wiring retainer (2).
12. Remove lower securing bolt of starter (arrow).
13. Remove starter downwards from vehicle.
14. Tighten threaded connections to specified torques .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing housing for ATF supply unit and stator shaft · 2 torque figures
• Installing gearbox, vehicles with 1.2 l/77 kW petrol engine
• Installing gearbox, Jetta 2011 with 1.2 l engine and 1.4 l engine
• Removing and installing poly V-belt pulley with freewheel, manufacturer: Valeo · 4 torque figures
• Checking fuel delivery rate, engine code BSX – VW Touran I 2.0