Removing and installing starter, 1.4 l, 103 kW or 110 KW TSI engine with manual gearbox MQ 200-6F — VW

🧭 Before you start

Fits: VW Touran I (1T, 2003–2015)

📋 Procedure

1. Disconnect battery .
2. Remove air filter housing Engine mixture preparation24Repairing injection system; Removing and installing air filter.
3. Release connector (1) and disconnect.
4. Push protective cap (1) off solenoid switch downwards in direction of (arrow).
5. Undo nut (1) and take positive wire (2) off thread of solenoid switch.

6. Undo nut (1) from upper securing bolt of starter and remove earth cable (2).
7. Remove upper securing bolt of starter, lies behind.
8. Remove noise insulation General body repairs, exterior50Body front; Noise insulation.
9. Undo nut (1) are remove wire holder (2) from lower securing bolt of alternator.
10. Remove lower securing bolt of starter (2).
11. Remove starter (1) by taking it downwards out of the vehicle.
12. Tighten threaded connections to specified torque given in assembly overview .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Repairing selector mechanism – VW Polo 6C 2.0
• Removing and installing gearbox oil cooler – VW 2.0
• 5-speed manual gearbox 02C, four-wheel drive — Renewing propshaft flange oil seal on rear final drive (final drive removed)
• Removing and installing starter, vehicles with 2.0 l TDI engine, 103 kW, manual gearbox MQ350
• Removing and installing starter, 2.0 l TSI engine with 147 kW or 155 KW, dual clutch gearbox DQ250-6F