Removing and installing starter, 1.4 l petrol engine, 90/110/118 kW, dual clutch gearbox — VW

🧭 Before you start

Fits: VW Jetta VI (16, 2010–2018)

📋 Procedure

1. ⚠ When disconnecting or reconnecting the batteryA, adhere strictly to the procedure described in the workshop manual . — Disconnect batteryA.
2. Remove air filter housing 24Air filter; Removing and installing air filter housing.
3. Release and detach connector (terminal 50) (1).
4. Pull protective cap (1) off solenoid switch in (direction of arrow).
5. Remove nut (1) and remove positive wire (2) from solenoid switch.

6. Undo nut (1) from upper starter bolt and remove earth wire (2).
7. Remove upper starter bolt.
8. Remove lower bolt (arrow) of starter.
9. Remove starterB upwards from vehicle.
10. Tighten threaded connections to specified torque .
11. Reconnect batteryA.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Checking turbocharger
• Removing and installing camshaft adjuster and exhaust camshaft sprocket
• Checking accelerator pedal position sender (121-pin control unit)
• Removing and installing ABS control unit J104/ABS hydraulic unit N55, LHD vehicles
• Servicing diesel electric heater -D2L-