Removing and installing spoiler, Polo »Blue GT«, Polo »R-Line« — VW

🧭 Before you start

Fits: VW Polo 6C (2014–2017)

Don't miss

• When removing roof spoiler, cutting wire should not be used due to the risk of damage to the painted areas. — Thread cutting cord (3) in at one corner between rear lid and roof spoiler (1).
• If the adapter has not been removed, the roof spoiler latches onto the adapter on the rear lid.
• Check fitting of roof spoiler (1).

📋 Procedure

1. ⚠ When removing roof spoiler, cutting wire should not be used due to the risk of damage to the painted areas. — Thread cutting cord (3) in at one corner between rear lid and roof spoiler (1).
2. Cut through adhesive sealants on one side of roof spoiler using a "“sawing”" motion with both pull handlesV.A.G 1351/1(2).
3. Also cut through sealant materials on other side.
4. Release roof spoiler at marked points using wedge T10383.
5. Lift roof spoiler and release from fasteners located on underside.

6. Remove roof spoiler. [Note: If the adapter has not been removed, the roof spoiler latches onto the adapter on the rear lid.]
7. Repair instructions
8. Using hand cartridge gunV.A.G 1628(5), apply adhesive bead (4) and adhesive spots (2) on left and right sides of roof spoiler (1).
9. Pull protective film off double-sided adhesive tape (3).
10. With the help of a second mechanic, fit roof spoiler (1) in direction of (arrow) on rear lid (2) and press on firmly. [Note: Check fitting of roof spoiler (1).]

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing tandem pump and fuel pump – VW 4.9 TDI · 2 torque figures
• Removing and installing steering rack, right-hand drive (2nd generation) up to model year 2008
• Removing and installing exhaust pipe for auxiliary heater · 3 torque figures
• 6-speed dual clutch gearbox 02E Volkswagen R GmbH — Removing and installing bevel box, Golf 2004 ► and Passat 2006 ► with V6 engine
• Removing and installing oil supply line for turbocharger · 2 torque figures