Removing and installing side piece of spoiler, Polo »Blue GT« — VW

🧭 Before you start

Fits: VW Polo 6C (2014–2017)

Don't miss

• Only the left side is shown. The right side is analogous.
• Always ensure that the correct materials are used for the various individual steps. — Lay side spoiler (1) on rear window and mark position with adhesive tape (5).
• The application must be performed in one motion without interruption using primer applicator.A complete film must cover the glass surface.

📋 Procedure

1. Insert cutting cord (3) under (arrow) under side spoiler (1).
2. Cut through adhesive sealant using pull handlesV.A.G 1351/1(3) and cutting cord (2).
3. Warm upper section side spoiler (1) near roof spoiler (4) using hot air blowerV.A.G 1416.
4. Carefully pull side spoiler (1) off rear window and roof spoiler. [Note: Only the left side is shown. The right side is analogous.] [Note: The side spoiler (1) is factory-bonded with double-sided adhesive tape (2) and (3)]
5. ⚠ Always ensure that the correct materials are used for the various individual steps. — Lay side spoiler (1) on rear window and mark position with adhesive tape (5).

6. Remove side spoiler (1).
7. Clean rear window with cleaning solution.
8. Then apply glass and paint primer (6) to bonding surfaces on rear window and allow to dry. [Note: The application must be performed in one motion without interruption using primer applicator.A complete film must cover the glass surface.]
9. Apply glass and paint primer to bonding surfaces (4) of side spoiler (1) and allow to dry.
10. Apply 1-pack window adhesive to bonding surface (3) of side spoiler (1).
11. Align side spoiler (1) with roof spoiler.
12. Pull backing (2) off double-sided adhesive tape from top to bottom.
13. Press side spoiler (1) vertically against rear window in (direction of arrow).

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Adjusting headlight installation position · 2 torque figures
• Renewing valve stem seals with cylinder head removed – VW CDLJ
• Removing and installing front seat cushion cover and padding · 1 torque figures
• Installing rear lid hinge – VW Sharan II / SEAT Alhambra · 3 torque figures
• Adjusting rear glass panel – VW Touareg II · 3 torque figures